AquaScape DIY Waterfall Kit Manual De Instrucciones página 12

STEP 7
PLACE UNDERLAYMENT AND LINER
**Remove any sharp objects from the excavated area that
may damage the liner.
• Remove the AquaBlox
the basin (in step 6) in order to install the underlayment
and liner.
• Unfold the underlayment fabric and place into the
excavated basin. Starting from the bottom, remove the
slack from the underlayment, making sure it conforms into
all of the sides. Make sure you leave enough underlayment
to cover your stream and waterfall location
12
and Pondless Waterfall Vault from
® ®
• Place the EPDM liner on top of the underlayment.The
installation process is the same as the underlayment,
starting at the bottom and contouring the liner up and out
of the basin.
• Try to get large folds out, the main goal is to have the
liner lying flat and going into all corners. Don't try to get it
perfect, you will hide the liner with rocks and gravel later.
• Make sure the liner is high enough around the edges of
the basin. Problems can be fixed by readjusting the liner
into the excavation, backfilling (making the basin smaller)
in areas where there is not enough liner.
www.aquascapeinc.com