AquaScape DIY Waterfall Kit Manual De Instrucciones página 15

• The kink-free pipe coming from the Waterfall Spillway can
be trimmed to proper length and inserted through the slot
on the side of the Pondless
• Lower the pump into the Pondless
rotate the Rotational Ball fitting to line up with the tubing.
Attach tubing to the fitting and then tighten hose clamp to
secure tubing onto the fitting.
• The cord from the pump can be buried just beneath the
stone and gravel and run to the electrical supply.
Please note: In some instances the tubing/hose may
be tight and difficult to use with hose fitting. If this is
the case heat the hose with the use of a hair dryer
or simply dip the hose for a few seconds in very hot
water. Lubrication can also be used, such as silicone
grease or vegetable oil.
Waterfall Vault.
®
Waterfall Vault and
®
CAN 1-866-766-3426 |
STEP 12
ADD ROCK AND GRAVEL
• Set larger boulders (6" – 18") around the perimeter of the
basin on top of the AquaBlox
basin.
• Add 1 ½" to 2" size
gravel to cover the
AquaBlox in the
®
basin.
• A finishing layer of
decorative gravel can
be added to the top if
desired.
US 1-866-877-6637
to support the edges of the
®
15