AquaScape DIY Waterfall Kit Manual De Instrucciones página 16

STEP 12
CONT...
• The built-in water level
inspection port allows
the lid of the Pondless
Waterfall Vault to be buried
just below the surface of
the rock.
STEP 13
BUILD THE WATERFALL
• Position your waterfall so it is facing the main viewing
areas.
• Build waterfall and stream approximately 3' from the
AquaBlox , providing enough liner at the top of the
®
waterfall to wrap over the top of the Waterfall Spillway.
16
®
www.aquascapeinc.com
• Tamp the ground under
the desired location for
Waterfalll Spillway to
provide a flat level surface.
• Set the Waterfall Spillway
into place.
• Pull your underlayment and
liner into place.
• You can adjust the height
of the Waterfall Spillway by
adding gravel underneath the Spillway (on top of the liner)
until you have reached your desired height.
• The gravel will also provide a suitable base for leveling the
Waterfall Spillway.