CyberPower Professional Rack Mount LCD Series Manual De Usuario página 7

BATTERY REPLACMENT PROCEDURE:
1. Remove the front panel
on the right side.
3. Remove the two retaining
screws of the cable connectors.
5. Remove the three retaining
screws.
REMINDER! The used batteries are hazardous wastes and must be disposed through recycling. Most retailers
that sell lead-acid batteries collect used batteries for recycling, as required by the local regulations.
Copyright © 2015 CyberPower Systems, Inc.
BATTERY REPLACEMEN (continued)
2. Remove the two retaining screws
of the cable protection cover then
remove the cover.
4. Disconnect the black wire and red
wire from the battery.
6. Put the new battery packs back into the
compartment. Tighten up the screws and
replace the cable protection cover and the
front panel. Recharge the unit for 12
hours to ensure the UPS performs
expected runtime.
6