Steamfast SF-540 Guia Del Usuario página 7

CONNECTING POLE TOP
1. Look at underside of Pole Top, and locate two guide tabs
(FIGURE 3-A).
2. Align Pole Top guide tabs with guide grooves on SECTION 1
of Telescopic Pole.
NOTE: It is recommended to orient Pole Top so Nozzle
Cradle faces forwards towards front of the unit.
3. Slide Pole Top onto SECTION 1 of Telescopic Pole (FIGURE 3-B).
Press down firmly until Pole Top fits securely in place.
CAUTION: To prevent steam from causing bodily injury or
damage to surfaces, always hang Steam Nozzle on Steam
Nozzle Cradle when not in use. Do not lay Hose on the floor
as condensation may build up, causing unwanted water
droplets in the steam.
ADJUSTING TELESCOPIC POLE
To adjust the length of SECTIONS 1, 2 & 3 of the Telescopic Pole:
1. Release extension lock directly below SECTION 1 by swinging
hinge outward as shown. SECTION 1 can then be extended /
retracted (FIGURE 4).
2. Once SECTION 1 is at desired length, close hinge to once again
secure extension lock.
3. Repeat STEPS 1 & 2 for SECTIONS 2 & 3 of the Telescopic Pole,
using the extension lock directly below each of those sections.
NOTE: It is recommended to extend Telescopic Pole to its full
height during steamer operation; this will ensure optimal
steam flow through the Hose.
3-A
3-B
FIGURE 3
FIGURE 4
ENGLISH | 7