Filling With Water - Steamfast SF-540 Guia Del Usuario

FILLING WITH WATER

1. Remove Water Tank from main unit.
2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counter-
clockwise direction (FIGURE 7-A).
3. Fill Water Tank with water through Valve Cap hole. At full capacity, the Water Tank holds 78 oz
(2,307 ml) of water, and will provide a continuous steam time of approximately 80 minutes.
For quick steaming tasks, a smaller amount of water can be used.
NOTE: In order to minimize potential mineral build-up and prolong the life of your
Deluxe Fabric Steamer, distilled or de-mineralized water is recommended.
CAUTION: Only water and Steamfast Lemon Acid should be used in unit – other
chemicals or cleaning agents may cause internal damage. Do not attempt to substitute
any other water tank for the one designed for use with this unit.
4. Replace Valve Cap by rotating it in a clockwise direction.
5. Place Water Tank back onto main unit (FIGURE 7-B). The sound of water flowing from Water
Tank into Water Reservoir should be audible for a short period of time.
NOTE: Water Tank can be removed and refilled at any time during operation – there is no
need to turn unit off or allow any cooling period.
IMPORTANT: Do not attempt to operate unit with an empty Water Tank.
7-A
Using Your
Deluxe Fabric Steamer
FIGURE 7
7-B
ENGLISH | 9