Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TOP PANEL FEATURES
8
4
4
5
6
7
7
20
11
9
INPUT CONTROLS
1.
CHANNEL FADER – Adjusts the audio level of the corresponding channel.
2.
INPUT SELECTOR – Selects the input source to be routed to the corresponding channel. Input jacks
are located on the rear panel.
3.
CHANNEL GAIN – Adjusts the channel's pre-fader and pre-EQ gain level.
MICROPHONE CONTROLS
4.
MIC TREBLE & BASS – Adjusts the treble (high) and bass (low) frequencies of the audio for both mic
inputs.
Tip: If you experience feedback when using a microphone at loud levels, try turning down the high
(treble) frequencies.
5.
TALKOVER SWITCH – Toggles between three "talkover" settings, allowing you to speak over the
music. (Talkover only applies to MIC 1. MIC 2's level can only be controlled by its MIC GAIN knob.)
-12dB – Reduces the combined levels of Channels 1-4 to -12dB (an appropriate "talkover" level).
ON – Leaves Channels 1-4 at the levels you designated while the mic remains on.
AUTO – Automatically reduces the combined levels of Channels 1-4 to -12dB whenever you talk
into the DJ MIC.
6.
TALKOVER SENSITIVITY – Adjusts the volume threshold at which auto-talkover activates. The higher
the sensitivity, the quieter you need to speak into the mic to activate auto-talkover.
7.
MIC GAIN – Adjusts the audio level of the microphone signal. The MIC 1 knob controls the volume of
DJ mic input. The MIC 2 knob controls the volume of the MIC 2 input.
8.
MIC 1 INPUT – Connect a microphone to this input with an XLR or ¼" cable.
CROSSFADER CONTROLS
9.
CROSSFADER ASSIGN – Selects which input channel will be heard when the crossfader is moved
towards this knob. All channels not assigned will remain active.
10.
CROSSFADER – Blends audio between the channels assigned to the left and right side of the
crossfader.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then
remove the screws holding it in position. Replace the fader with a quality authorized replacement from
your local Numark retailer only.
11.
FADER START – Enables or disables "fader start" on the corresponding side of the crossfader. When
fader start is enabled on one side, moving the crossfader toward that side will cause any fader start-
compatible device (connected to the FADER START output on the rear panel) to start playing.
3
3
2
2
1
1
20
20
10
3
3
16
2
2
1
1
14
20
20
11
9
17
6
19
15
12
18
13
21
22
25
26
23
24
Publicidad
Tabla de contenido
