Using Coffee Beans; Preparing Hot Water - Bosch TCA 52 Serie Instrucciones De Uso

en

Using coffee beans

This fully automatic espresso/coffee
machine grinds beans freshly for each
brew. If possible, use only beans for fully
automatic coffee and espresso machines.
Deep­freeze or store in a cool place in
sealed, airtight containers. Coffee beans
can be ground while frozen.
Important: Fill the water tank with fresh
water every day. The tank must always
contain sufficient water for operating the
appliance. Do not allow it to become empty.
Tip: Pre­warm cups, especially small, thick
espresso cups, by placing on the cup shelf
14 or rinsing with hot water.
The appliance must be ready for use.
● Place the prewarmed cup(s) under the
coffee outlet 9.
● Press
5 K
or to select the desired
coffee strength. The coffee is brewed and
dispensed into the cup(s).
● Coffee delivery stops automatically when
the selected quantity has been dispensed
(factory setting approx. 125 ml).
i
The brewing process can be terminated
at any time by pressing the coffee
dispensing button
Extra coffee
It is possible to dispense the same amount
of coffee a second time.
● Just press the coffee dispensing button
5 K
or within 3 seconds after brewing is
complete.
Note: The second cup is brewed using the
previously ground coffee.
5 K
or .
Changing volume
dispensed
It is possible to change the factory setting
(approx. 125 ml) for the volume of mild or
strong coffee to be dispensed.
● Press and hold the coffee dispensing
5 K
button or until the desired volume of
coffee has been delivered (range approx.
30 – 220 ml).
i The volume can be changed again at
any time. To restore the factory setting of
approximately 125 ml, simply reset the
appliance.
Reset: Switch the appliance to stand­by
and remove the trays 17 and 18. Press
and hold the dispensing buttons
simultaneously for at least 5 seconds. The
LEDs 7a, b, c and d (
briefly. Replace the trays 17 and 18 and
press the stand­by button
appliance on again.

Preparing hot water

The appliance must be ready for use.
This function allows water to be heated for
a cup of tea, for example.

Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts!.
● Place an appropriate cup under the
nozzle 8.
● Push the sleeve on the nozzle 8 all the
way down.
● Turn the dial 6 to

Risk of scalding
!
When the dial is set to
may sputter a little. Do not touch the nozzle
8 or point it at anyone.
● End the process by turning the dial 6
back to O.
5
and
H I S J
, , , ) light up
a
to switch the
g h
/ .
g h
/ , the nozzle
TCA52 09/2007
13
K