4. INTRODUCTION TO BLUETOOTH
Pairing Sequence
Note:
• Please refer to Clarion Bluetooth
manual for the Bluetooth
Between Bluetooth
Bluetooth
1. Make sure the Transmitter is connected to an audio source.
2. Make sure the car stereo source mode is switched to 'AUX' mode.
3. Set the Transceiver unit in pairing mode. Please refer "Activating Bluetooth
Transceiver pairing mode" on page 16.
4. Set the Transmitter unit in pairing mode.
5. Music starts automatically upon successful pairing.
Notes:
• You do not have to enter a dedicated pin code for pairing these two devices, as
you do with a mobile phone.
• During pairing mode, the Transceiver unit should show a slower alternate red/blue
LED. Make sure that the Transmitter and Transceiver are not paired to any other
Transceiver or Transmitter respectively.
• Please refer "Understanding The Transceiver Unit Indicators" on page 15 for
further details.
10
1EN_OM_Receiver BLT370.indd 10
®
Audio Transmitter
®
BLT370
Audio Transmitter and Cradle for iPod owner's
®
Audio Transmitter operation below.
®
Audio/Mobile-phone Transceiver and
"PAIRING"
®
®
4/5/07 2:14:32 PM