Installation; Installing Blt370 - Clarion BLT 370 Manual De Instalación

3. INSTALLATION

Installing BLT370

This Transceiver unit is used to receive audio signals via Bluetooth
technology from other Bluetooth
The attached cable has a pair of auxiliary output, a 12V power connector (with
LC box attached) and a TEL-INT (Telephone interrupt) pin.
TEL-INT.
(Brown wire)
Gnd (Black wire)
Instructions
1. Connect the 12V (Acc and Gnd) to car supply.
2. Connect the RCA-L and RCA-R to car stereo auxiliary (AUX) input.
Alternately, you can use the RCA to 3.5mm jack cable (included) to connect
to car stereo that supports 3.5mm AUX input.
3. Connect TEL-INT. pin to car stereo telephone mute line (if this feature is
supported).
4. Make sure that the car stereo system's telephone interrupt is ON.
6
1EN_OM_Receiver BLT370.indd 6
RCA to 3.5mm
jack cable
White jack
Acc (Red wire)
Figure 1: System diagram
BLT370
device and stream it to the car audio system.
®
Bluetooth
phone Transceiver unit
Red jack
To car stereo AUX-IN
RCA-L
RCA-R
(White
(Red jack)
jack)
LC Box (with fuse)
wireless
®
Audio/Mobile-
®
Internal
micro-
phone
2.5mm
External
microphone
(Optional)
4/5/07 2:14:30 PM