Usage - CPS AC750 Manual De Instrucciones

1.2 Usage

1.2.1 When using the meter, select the right function and
measuring range.
1.2.2 Don't make measurements that exceed indicated values in
each measuring range.
1.2.3 When measuring circuits with the meter connected, do not
contact with probe tip (metal part).
1.2.4 If voltage to be measured is more than 60V DC or 30V AC (RMS),
always keep your fingers behind finger protection device.
1.2.5 Do not measure voltage greater than AC 750V.
1.2.6 When selecting the manual measuring range, if you don't
know the value to be measured, choose the highest
measuring range and decrease gradually until the correct
range is displayed.
1.2.7 Before rotating selection switch to change measuring function,
remove probe from the circuit to be measured.
1.2.8 Don't measure resistors, capacitors, diodes and circuit
connections with power.
1.2.9 During tests of current, resistors, capacitors, diodes and
circuit connections, avoid connecting the meter to voltage source.
1.2.10 Do not measure capacitance before capacitor is discharged
completely.
1.2.11 Do not use the meter in explosive gas, vapor or dusty
environment.
1.2.12 If you find any abnormal phenomena or failure on the meter,
stop using the meter immediately.
1.2.13 Do not use the meter unless the meter bottom case and the
battery cover are completely fastened in original places.
1.2.14 Don't store or use the meter in direct sunlight, high temperature
and high humidity.
Pg 02