Teka IOVEN Manual Del Usuario página 44

IMPORTANT
Do not open the oven door until the Hydro-
clean function has finished.
©
The cooling phase is necessary for the cor-
rect operation of the function.
1. When the end time is reached, a buzzer
alarm is heard until any point on the screen
is pressed or until the ON/OFF button is
pressed.
2. The oven displays the time screen.
Pyrolytic self-cleaning function
WARNING
Before carrying out the pyrolytic cleaning
cycle, carefully read the safety instructions
found at the beginning of the Installation and
Maintenance booklet.
This feature allows you to run the pyrolytic
cleaning cycle during which built-up grease
deposits are burned off by the high temperatures
inside the oven.
Generally, a pyrolytic cycle is recommended
after every 4-5 uses; choose the most suitable
programme depending on how dirty your oven
is. For very dirty ovens, choose a longer cycle.
During the pyrolytic cycle the light inside the
oven will remain off.
44
User's Guide
The Hydroclean function is run at low tem-
©
perature. However, the cooling times may vary
with the ambient temperature.
WARNING
Before touching the interior surfaces of the
oven, make sure that oven has cooled.
If after running the Hydroclean
more thorough cleaning is required, use neutral
detergents and non-abrasive cloths.
PROGRAMMING THE
PYROLYTIC FUNCTION
IMPORTANT
Before carrying out the pyrolytic cleaning
cycle, remove all accessories and dishes from
the oven, including the shelf runners and/or
telescopic guide rails. To clean these follow
the instructions in the Installation and Mainte-
nance booklet that comes with your oven.
WARNING
Clean any spillages or excess dirt, as during
the pyrolytic cleaning cycle these can ignite
and become a fire hazard.
WARNING
Before running the pyrolytic cycle, ensure
that the oven is properly closed.
function, a
©