Dashboard Icons; Assembling Your Minipro - Segway NINEBOT miniPRO Manual Del Usuario

4

Dashboard Icons

Power Button
Lock
Bluetooth
Speed Limit
Power Level
Power Turn ON/OFF. The miniPRO will automatically power OFF when idle for 10 minutes,
Button
or when laid down (horizontal) for over 30 seconds.
Enable Lock Mode via the App. The miniPRO will vibrate, flash its lights, and sound an alarm
Lock
if anyone moves it. The App will also alarm. The miniPRO will not balance in Lock Mode.
When Bluetooth is enabled but not connected to a smart phone, this icon will blink.
Bluetooth
When the Ninebot by Segway App is connected to the miniPRO, this icon will glow steadily.
Speed Enable and adjust Speed Limit Mode via the App. When the icon is illuminated the miniPRO
is limited to 7 km/h. This speed limit can be adjusted in the App. As you approach the speed
Limit
limit, the miniPRO tilts back.
Indicates the remaining battery life. When the battery is nearly empty this icon blinks and the
miniPRO beeps, indicating that you need to charge your miniPRO. When less than 30%, your
Power
Level miniPRO will gradually reduce the max speed limit. Use the App to read the remaining power
and estimated remaining range.
04
5

Assembling Your miniPRO

Install the steering bar
2
1 Insert the steering bar into the
Open the tool-free release as shown.
mainframe steering socket.
Check the Power ON/OFF status after assembly.
For your safety, your miniPRO is not activated at this time
Until activated, the miniPRO maintains a very low riding speed and steering sensitivity, and should not be ridden. Install the
Ninebot by Segway App on your mobile device (with Bluetooth 4.0 or above), connect to the miniPRO with Bluetooth, and follow
the App instructions to activate your miniPRO and follow the training procedures.
Adjust the knee pad height
Rotate height adjustment Lift the knee pads to desired height.
knob counter-clockwise. Rotate height adjustment knob
clockwise to tighten.
3
Close the tool-free
release to secure.
and will beep occasionally after Power ON.
Lift the guide bar to help steer
the miniPRO without a rider
when powered on. Do not use
to lift or carry the miniPRO.
05