Raising And Lowering The Presser Foot; Changing The Presser Foot; Removing And Attaching The Presser Foot Holder - Baby Lock ZEAL BL35B Instrucción Y Guia De Referencia

e
w
q
e
w
q
e
e
w
q
w
r
14

Raising and Lowering the Presser Foot

The presser foot lifter raises and lowers the presser foot.
You can raise the foot about 1/4" (0.6 cm) higher than the
normal up position for easy removal of the presser foot, or
to help you place heavy fabric under the foot.
q Lowered position
w Normal up position
e Extra up position

Changing the Presser Foot

To remove:
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the lever on the back of the foot holder.
q Lever
CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
Do not push the lever down to prevent it from being
broken.
To attach:
Place the desired presser foot, so that the pin on the foot
lies just under the groove on the foot holder. Lower the
presser foot lifter to lock the foot in place.
w Groove
e Pin

Removing and Attaching the Presser Foot Holder

WARNING:
Turn OFF the power switch before detaching or
attaching the presser foot holder.
To remove:
Remove the setscrew by turning it counterclockwise with
a screwdriver and remove the presser foot holder from the
presser foot bar.
To attach:
Match the hole in the presser foot holder with the
threaded hole in the presser foot bar. Fit the setscrew into
the hole. Tighten the screw by turning it clockwise with a
screwdriver.
q Setscrew
w Presser foot holder
e Hole
r Threaded hole