Fm Operation - auna Connect System S Manual Del Usuario

1. During DAB mode, press the MENU button and press the  / buttons
to select DRC and press the ENTER button to confirm.
2. Press the  / buttons to select DRC high/low/off and press the ENTER
button to confirm the setting.
Station Order
You may wish to arrange the station listing order.
1. During DAB mode, press the MENU button and press the  / buttons
to select Station Order and press the ENTER button to confirm.
2. Press the  / buttons to select Alphanumeric/Ensemble/Valid order
and press the ENTER button to confirm the setting.
Saving and Recalling Preset Station
Refer to "Preset Stations" and "Recalling a Stored Station" under Internet
Radio section for instruction.

FM OPERATION

To switch the unit to FM mode, press the MODE button repeatedly to switch
to FM mode. The display will show the frequency.
Auto Scan
Press the SCAN button on the unit or on the remote control to start
searching for a station. Once a station has been found, the scanning wil
lstop automatically.
Manual Tuning
To search for FM stations manually, press the TUNING buttons repeatedly
until your desired frequency is reached.
With FM radio, it may be necessary to fine tune each station by pressing
the TUNINGbuttons repeatedly. Each press will adjust the frequency by
0.05 MHz. If reception is still poor, adjust the position of the aerial or try
moving the radio to another location.
Scan Setting
1. Press the MENU button to access FM menu.
2. Press the / buttons to select Scan setting and then press the ENTER
button to confirm.
3. Press the / buttons to select Yes to receive Strong stations only and
then press the ENTER button to confirm.
EN
FM
radio
FM Radi o
59