Setting The Alarm - auna Connect System S Manual Del Usuario

EN
66

SETTING THE ALARM

1. Press the TIMER button on the remote control, the display shows "Alarm
(1 or 2): Off [hh:mm]".
2. Press the  / buttons to select the Alarm number (1 or 2) and then
press the ENTER button to start the setting of the following parameters.
3. For the following setting, press the  / buttons to select then press
the ENTER button to confirm.
Enable Off/ Daily/ Once/ Weekends/ Weekdays
Time (Alarm On time)
Mode Buzzer/ Internet radio/ DAB/ FM
Preset Last Listened/ (Preset station)
Volume Muted, 1-32
Save Save and confirm the alarm setting
4. Finally, select "Save" and press the ENTER button to save the alarm
setting. When the alarm is set, the alarm icon will appear on the display
during standby mode.
5. To turn off the alarm when it sounds, press the STANDBY or ALARM
button.
During Standby mode, press the ALARM button repeatedly to turn the
saved Alarm on/off.
Cancelling the Alarm
1. Press the TIMER button on the remote control, the display shows "Alarm
(1 or 2): On [hh:mm]"..
2. Press the  /, buttons to select the Alarm number (1 or 2) and then
press ENTER to start the setting of the timer.
3. Press the  / buttons to select "Enable" then press the ENTER button
to confirm.
4. Press the  / "buttons to select "Off" then press the ENTER button to
confirm.
5. Finally, select "Save" and press the ENTER button to save the setting.
If no button is pressed within approx. 15 seconds, the unit exits timer setting
mode automatically.