Level Refrigerator - KitchenAid Architect Serie Manual De Instalación

4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
1
5. Reinstall the handle-side and top trims.
6. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel-side down on a soft working surface.
2
1. Top grille
2. Cabinet side trim
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
1. Bottom rail
2. Nuts
22
1. Panels
1 2
3. End Cap
4. Top rail
4. Slide the decorative panel into the top grille channel and
reattach the end caps.
1
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
NOTE: Classic and Overlay Series door panels must be installed
before leveling.
1. Open the doors and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
2. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from left to right.
1
2
3. Place the level(s) on shelf or shelves as shown. Check to see
whether the refrigerator is level from front to back.
1. Backer panel
2 1
1. Top grille
2. Cabinet side trim

Level Refrigerator

1
2
1. Level to check left to right leveling
2. Level to check front to back leveling
1. Rear leveling bolt
2. Front level bolt
2
2
1
2