Kübler CODIX 541 Instrucciones De Puesta En Servicio página 17

Tachometer/Frequency meter
C C O O D D I I X X 5 5 4 4 2 2
(CODIX 544: Operating mode frequency
meter)
1. Description
• 6 digit frequency meter
• Red LED display, character height 14 mm
• Display range from 0 to 999 999
• Leading zeros suppression.
• Programming via two setting keys on the front
side
• During programming, the display guides the
user with text prompts
• Value conversion and display in 1/s or 1/min
• With AC power supply: sensor supply
voltage 24 V DC ±15 %/100 mA
• Optional optocoupler output
2. Inputs
INP A
Dynamic count input.
3. Optocoupler output (optional)
Active at f=0. Can be used e.g. to activate a „No
operation" lamp.
4. Programming routine
The programmable parameters of the device are
described below, in the order in which they can
be set. The device is fully programmed after one
pass of the routine.
The first values stated correspond to the factory
settings
4.1 Polarity of the inputs
npn: switching for 0 V
pnp: switching for +U B
4.2 Switching on the 30 Hz filter
4.3 Multitplying factor
4.4 Dividing factor
4.5 Decimal point
30 Hz filter off (f max )
30 Hzfilter on
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0" is not accepted!
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0" is not accepted!
The decimal point defines
the resolution
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
6