Publicidad
Idiomas disponibles
Idiomas disponibles
Use extreme force when tightening the lever in Step 14. Test the installation!
StEP
Assemble the
two halves
of the pod
loosely onto the
crossbar.
Single screw hole indicates front.
insert skewer shaft
through pod.
Hold the adjustment knob.
Turn handle clockwise to
remove the shaft.
Compress
the strap
into the red
button slots.
1033569C-2/12
Position the pod
LoadWarrior
so that the front
users:
dips slightly.
Attach the tube
sleeve onto the
crossbar.
fRonT
(side view)
Insert the skewer shaft while applying
pressure to the pod cover.
Skewer direction is your choice;
consider lock access.
insert the carriage
bolt vertically into
the lower hole.
tighten the screws
using the supplied
hex wrench.
the pod must not rotate!
Tighten until
there is no longer
a gap between
the pod halves.
Attach the shaft to handle.
Hold the shaft at the far end. Join the
handle with the shaft, turn the shaft
counter-clockwise.
noTE: Adjustment knob
will turn with shaft.
SQUARE BARS
ONLY:
the angled hole is for
very short or very wide
crossbar distances.
Attach the pod cover.
Pod cover
must be in
place at all
times for safe
operation of
bike carrier.
Leave plenty of
skewer showing.
Attach the correct
bracket.
Publicidad
