Audio-Technica M3 Serie Configuración Y Funcionamiento página 8

P52002_M3-System_OM 2/27/08
8
How to make setting changes on the M3R Stereo Receiver
To access the M3R Stereo Receiver's user-changeable functions, Touch
the Set button. The top line of the transmitter display shows " FREQ ".
Touch the Down arrow button to scroll through the functions that may
be changed. (See the chart below.)
To change a receiver function, when the function to be edited is displayed,
touch the Set button. (Note: When the M3R Stereo Receiver is first
powered on, the LCD's timed backlight is on. After the backlight
has timed out, a touch of the Set or Up/Down arrows turns the
light on again. In this case, you will need to touch the Set button
twice in order to change a receiver function, since the first touch
will simply turn the backlight on.)
M3R Stereo Receiver Functions
Function Menu
▲▼ Frequency
▲▼ Group
▲▼ User
▲▼ Scan **/***
▲▼ Limiter
▲▼ Squelch
▲▼ Mode
▲▼ Output
▲▼ Aux level
▲▼ Mic Volume (if Aux set to Mic)
▲▼ Program
▲▼ Reset
▲▼ Quit (exit Menu)
* Continue in the same Up/Down direction and choices "wrap around" to the other end of the range.
9:08 AM Page 8
Default Value
Lowest in band
G1 - 1
U1 - 1
No value
3 (maximum limiting)
0
Stereo
Stereo
Line
1
-
QUIT
The small word " EDIT " will appear in the display. Touch the Up/Down
arrow buttons to scroll through the available choices for the function,
stopping on the desired choice. Hold the Mode/Set button to accept the
new choice. " STORED " appears in the display when the choice is
accepted. The receiver then returns to Menu mode. Continue this
process until all desired function-setting changes are complete. Note:
To escape from Edit mode without making any changes, touch the
Mode/Set button. " ESCAPE " appears briefly in the display, and the
receiver returns to Menu mode.
Choices (Edit)
Over 1250 discrete frequencies
G1 – G6 (16 channels each)
U1 – U3 (16 channels each)
Scan start
3, 2, 1, Off
Off, -1, 0, 1, 2
Stereo, Mono
Stereo, L/R Mix
Line, Mic
1 – 16
Create custom frequency groups
Choose OK to restore factory settings
Press Mode/Set once to exit
Wrap-around*
Yes
Yes
Yes
--
Yes
No
Yes
Yes
Yes
No
Continued on page 9