TecMate TestMATE Manual Del Usario página 3

5. Press the
Press «ENTER» button.
6. Press the
VRLA/GEL/AGM/SLA or STANDARD SLI.
Press «ENTER» to confi rm choice.
7. Press the
2-200 Ah.
Press «ENTER» to begin the test.
Note: When the battery is just charged or tested
in vehicle. The tester will pop up several steps to
make sure the surface charge is removed. Follow
up those steps to assure the accuracy.
8. Test the battery for few seconds.
9. Press the
not if tester asks. Press «ENTER» to confi rm choice.
10. When the test is completed, the display shows the actual volts , the actual CCA and %.
{Press the
One of six results will be displayed:
GOOD & PASS
xx,xx V
GOOD & RECHARGE
xx,xx V
RECHARGE & RETEST
xx,xx V
BAD & REPLACE
xx,xx V
BAD CELL & REPLACE
xx,xx V
LOAD ERROR
11. Press «ENTER» return to step 5 or remove the test clamps from the battery posts after
completion of testing batteries to end test.
key to select battery test.
key to select the battery type:
key to input the battery capacity:
key to select battery fully charged or
key to select: SOH (STATE OF HEALTH) or SOC (STATE OF CHARGE)}.
xxxx SAE
xxxx SAE
xxxx SAE
xxxx SAE
xxxx SAE
The battery is good & capable of holding a
charge.
The battery is good but needs to be recharged.
Battery is discharged, the battery condition
cannot be determined until it is fully charged.
Recharge & retest the battery.
The battery will not hold a charge. It should be
replaced immediately.
The battery has at least one cell short circuit. It
should be replaced immediately.
The tested battery is bigger than 200Ah. Or the
clamps are not connected properly.
Please fully charge the battery and retest after
excluding both previous reasons. If reading is the
same, the battery should be replaced immediately.
BATTERY TYPE
VRLA/GEL/AGM/SLA
SET CAPACITY
SURFACE CHARGE
IN VEHICLE?
TESTING
IS BATTERY
CHARGED ?
xxxx AH
YES
YES
3