Fresnel Lens; Fuse Replacement - Chauvet DJ COREpar 40 USB Guía De Referencia Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
COREpar™ 40 USB QRG

Fresnel Lens

AC Power
Power Linking

Fuse Replacement

IRC-6
(Infrared
Remote Control)
Mounting
Mounting
Diagram
This Fresnel lens produces a very even light that is soft at the edges, which
makes the COREpar™ 40 USB a 2-in-1 light. Attach the Fresnel lens easily
with the built-in magnets.
Magnetic
Fresnel Lens
WARNING! DO NOT plug anything other than a D-Fi™ USB into the
USB port. Doing so may cause damage to the product.
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
For the maximum number of COREpar™ 40 USB that can be power linked at
120 V or at 240 V, see the User Manual or the label on the product.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The COREpar™ 40 USB is fully compatible with the Infrared Remote
Control (IRC-6) from Chauvet. For more information on the IRC-6 or to
download instructions, go to www.chauvetlighting.com.
Before mounting this product, read the
Clamp
(such as the
CLP-15N from
Chauvet)
Double-bracketed
Yoke for Floor or
Overhead Mounting
Safety
Notes.
4
EN
Safety Cable
(such as CH-05
from Chauvet)
Bracket Adjustment Knob

Publicidad

Tabla de contenido
loading

Tabla de contenido