DJI FOCUS Handwheel 2 Guia Del Usuario página 6

Status LED Description
The status LED indicates the communication status after the Focus Handwheel 2 is powered
on. Refer to the table below for more information about the blinking patterns.
Blinking Patterns
Blinks quickly
Blinks slowly
Solid on
Settings
Setting Mechanical Limits
The two adjustable hard stop screws around the focus wheel can be used to limit the travel
range physically.
1. Loosen the hard stop screws, slide them to the desired positions and tighten.
2. The travel range of the focus wheel is now limited to the distance between the two hard
stop screws.
Adjusting the Stiffness
Turn the control knob at the center while holding the focus wheel to adjust the stiffness of the
wheel. Adjust the focus wheel until it reaches a stiffness or looseness that feels comfortable.
Description
Upgrade failed.
No device detected.
Working properly.
7