Astralpool LumiPlus RGB-DMX Guia De Inicio Rapido página 2

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be im-
plemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Projector LumiPlus, follow the instructions provided below:
1. ELECTRICAL CONNECTION
The projectors are supplied with a 2-wire 1.5mm2 Cu H07RNF cable.
This projector has been designed to operate only with a DMX control and with the DMX modulator from AstralPool (code
41107). It doesn't work with any other control system.
The transformer must be sized to provide the VA for each LED projector that is connected. See power table, last page.
2. CONTROL SYSTEM
Do not install the 12V ~AC power lines of the lamps
and modulators near possible electrical interference of
other signals.
It is necessary to install a modulator for each one of the
existing transformers in the installation.
The PAR56 DMX projector uses 3 DMX channels,
one for each of the 3 primary colours (red, green and
blue). The configuration of the DMX address should
be performed from the modulator. One modulator can
control a maximum of 15 projectors. For independent
control, each projector should have its own transfor-
mer and modulator. The different modulators should
be assigned channels that do not overlap with other
modulators.
DMX PRESENCE LED
INDICATOR
See manual of the DMX mains lead code 41107 for information regarding how to assing DMX
DMX LINE
TERMINATION
addresses to each LED projector and how to configure a system.
2
Projector line
Modulator line
DMX ADRESS
INDICATOR/SELECTOR