PERMASTEEL PG-40612SOLE Manual Del Usuario página 28

ASSEMBLY INSTRUCTIONS
40. Loosen side burner C05&C06 in side shelf by
unscrewing and removing the two front screws
holding the burner in place.Note: Do not loosen
electrode screw.
Hardware Used
NONE.
41. Remove the (2) pre-installed M4 × 10 screw
from gas valve A19 and set them aside.
Connect side burner wire tip C08 to the igniter pin
on the side burner gas valve as shown. Push down
hard to ensure it won't fall off.
Hardware Used
NONE.
42. Remove the 2 pre-installed screws from the
valve control stem and set them aside.
Insert valve control stem through hole in fascia. At-
tach gas valve to fascia with previously removed 2
screws. Do not tighten the screws.
Hardware Used
NONE.
40
C06
41
42
28
C05
A19
C08
A19