Troubleshooting; Corrective Action - PERMASTEEL PG-40612SOLE Manual Del Usuario

TROUBLESHOOTING

PROBLEM
Burner(s) will not
light using igniter.
(See Electronic
Ignition Trouble-
shooting also)
Continued on next
page.
POSSIBLE CAUSE
GAS ISSUES:
• Trying to light wrong burner.
• Burner not engaged with control
valve.
• Obstruction in burner.
• No gas flow.
• Vapor lock at coupling nut to LP
cylinder.
• Coupling nut and LP cylinder valve
not fully connected.
• Electrode cracked or broken;
"sparks at crack.
• Electrode tip not in proper position.
• Wire and/or electrode covered with
cooking residue.
• Wires are loose or disconnected.
• Wires are shorting (sparking) be-
tween igniter and electrode.
• Dead battery.

CORRECTIVE ACTION

• See instructions on control panel and
in Use and Care section.
• Make sure valves are positioned inside
of burner tubes.
• Ensure burner tubes are not obstructed
with spider webs or other matter. See
cleaning section of Use and Care.
• Make sure LP cylinder is not empty. If
LP cylinder is not empty, refer to "Sud-
den drop in gas flow."
• Turn off knobs and disconnect coupling
nut from LP cylinder. Reconnect and
retry.
• Turn the coupling nut approximately
one-half to three-quarters additional turn
until solid stop. Tighten by hand only -
do not use tools.
• Replace electrode(s).
Main Burners and Side Burner:
• Tip of electrode should be pointing
toward gas port opening on burner. The
distance should be 1/8" to 1/4". Adjust if
necessary.
• Clean wire and/or electrode with rub-
bing alcohol and clean swab.
• Reconnect wires or replace electrode/
wire assembly.
• Replace igniter wire/electrode assem-
bly.
• Replace with a new AA-size alkaline
battery.
41