Turntable Installation
Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly
Countertop Installation
Remove all packing material and accessories.
Examine the oven for any damage such as
dents or broken door. Do not install if oven is
damaged.
Installation
1.
Select
a
provide enough open space for
the intake and/or outlet vents.
12 inch(30cm)
3.0 inch(7.5cm)
OPEN
3.0 inch(7.5cm)
A minimum clearance of 3.0 inches
(7.5cm) is required between the oven and
any adjacent walls. One side must be open.
(1) Leave a minimum clearance of 12
inches (30cm) above the oven.
(2) Do not remove the legs from the
bottom of the oven.
a. Never place the glass tray upside down. The
b. Both glass tray and turntable ring assembly must
c. All food and containers of food are always placed
d. If glass tray or turntable ring assembly cracks or
level
surface
that
glass tray should never be restricted.
always be used during cooking.
on the glass tray for cooking.
breaks, contact your nearest authorized service
center.
Cabinet: Remove any protective film found
on the microwave oven cabinet surface.
Do not remove the light brown Mica cover
that
is attached
cavity to protect the magnetron.
(3) Blocking the intake and/or outlet openings
can damage the oven.
(4) Place the oven as far away
from radios and TV as possible.
Operation of microwave oven may
cause interference to your radio or TV
reception.
2. Plug your oven into a standard household
outlet. Be sure the voltage and the
frequency is the same as the voltage
and the frequency on the rating label.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If installed near or over a heat
source, the oven could be damaged and
the warranty would be void.
33
to
the
oven