Installation And Connection - CORBERO CMICP125 Manual De Instrucciones

Installing the turntable
Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly

Installation and connection

1.This appliance is only intended for domestic use.
2.This oven is intended for built-in use only.It is not intended
for counter-top use or for use inside a cupboard.
3. Please observe the special installation instructions.
4.The appliance can be installed in a 60cm wide wall-
mounted cupboard(at lease 55cm deep and 85cm off the
floor).
5.The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
6.The mains voltage must correspond to the voltage
specified on the rating plate.
7.The socket must be installed and connecting cable must
only be replaced by a qualified electrician.If the plug is no
longer to accessible following installation,an all-pole
disconnecting device must be present on the installation
side with a contact gap of at lease 3mm.
8.Adapters,multi-way strips and extension leads must not
be used. Overloading can result in a risk of fire.
The accessible surface may
be hot during operation.
Never position the glass tray upside down. Glass
tray movement should never be obstructed.
Always use both the glass tray and turntable ring
assembly during cooking.
All food and food containers should always be
placed on the glass tray during cooking.
If the glass tray or turntable ring assembly cracks
or breaks, contact your local authorised support
centre.
38