Installation Steps - LUND Elite Serie Instrucciones De Instalación

Preparation Before Painting / Installation
For RX Style Only (SKIP if you have SX or EX style)
Install the rivet screws and nuts to each of the rivet holes on the flare. Our rivets are designed to screw on to the fender flares only, and they shouldn't be touching the
vehicle body at all. Using hand tools, tighten nuts until fastener is snug. DO NOT OVERTIGHTEN as this may damage the fender flare.
Installation of the Rubber Seal
Before you start cutting any rubber seal, please study the diagram. Do not use the rubber seal in any other areas other than indicated; otherwise you will end up with
a shortage of rubber seal on your last flare. Start the installation of the rubber seal as indicated in the diagram. Then cut the rubber seal with a razor. Follow the same
instruction for the remaining flares.
*Each roll of the rubber seal provided is long enough to complete the 4 fender flares and with extra to spare, however we are not responsible for the improper use of
the rubber seal. Contact Lund International to purchase additional rolls of rubber seal.

Installation Steps

1. Start with any fender flare you like. If parts have protective film applied, please remove it now. First, holding the flare against the fender. Make sure that
all the body line is lined up, and insert the first mounting hardware towards the middle of the flare. That way it will hold up the flare.
2. Next, you will continue the installation of all the remaining hardware from the middle outwards. Before tightening any hardware, make sure the flare is
lined up correctly.
TIP: it may be a good idea to line up all the necessary hardware in order on the floor next to the wheel so you will have easy access to them, which will help
avoid any confusion and mistakes.
3. Finally, you will tighten the hardware fasteners if needed. If it's a clip type, make sure the clips are clipped into place. (refer to the diagram for correct
way to mount the hardware)
4. Now you can try to use your hand and lightly pry on the flare at the mounting location to see if any hardware is loose.
5. Repeat the same steps for rest of the flares.
Rubber Seal
Fender Flare
NOTE: Actual application may vary slightly from illustrations.
Front Flare
Rear Flare
Lever-Clip
(with Fastener screw)
U - Clip ( Push-In)
Lever-Clip
(Use exisiting screw)
U - Clip ( Push-In)
Page 2 of 3
Existing Screw
Use Rubber Seal here
Do NOT use Rubber Seal here