Important Safety Instructions; Safety Alert Symbol; Heater Characteristics / Specifications - BriskHeat SRL-ADJ Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

SAFETY ALERT SYMBOL

The symbol above is used to call your attention to instructions
concerning your personal safety. It points out important safety
precautions. It means "ATTENTION! Become Alert! Your
Personal Safety is involved!" Read the message that follows
and be alert to the possibility of personal injury or death.
DANGER
A person who has not read and understood all operating
Instructions is not qualified to operate this product.
DANGER

Do not immerse or spray any component of the control
system with liquid.

Keep volatile or combustible material away from
control and heating system when in use.

Keep sharp metal objects away from control and
heating system.

Use control and heating system only in approved
locations.

Do not modify this product. Modification will void
warranty.
Failure to observe these warnings may result in electric shock,
risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:

Only qualified personnel are allowed to connect
electrical wiring.

All electrical wiring must follow local electrical codes.

The person who performs the final installation / wiring
must be qualified for this work.

The end-user is responsible for providing a suitable
disconnect device.

The end-user is responsible for providing a suitable
over-current protection device. It is highly
recommended that a ground-fault circuit breaker be
used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
SRL-ADJ & SRP-ADJ
Silicone Rubber Heating Blankets
DANGER
Immediate hazards which WILL result in severe personal injury
or death.
WARNING
Hazards or unsafe practices that COULD result in severe
personal injury or death.
CAUTION
Hazards or unsafe practices that COULD result in minor personal
injury or property damage.
CAUTION

Inspect all components before use (see page 9).

Never handle the heater while it is in operation; always
disconnect the heater from the power source and allow
cooling prior to handling.

Do not wrap the heater over itself.

If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after heater is
allowed to cool.

Never operate a heater without an appropriate heat
sink (device being heated is considered a heat sink).

Do not operate heater above rated temperature value.

Fasten heater to device using approved methods only.

Do not use control and heating system if any
component is damaged.

Do not repair damaged or faulty control and heating
systems.

Do not crush or apply severe physical stress on any
component of system, including cord assembly.

Unplug control and heating system when not in use.
Failure to observe these warnings may result in personal injury
or damage to the heater.
3

HEATER CHARACTERISTICS / SPECIFICATIONS

Part Series
Operating Temperature Range
Max Power Density
Minimum Bend Radius
Min Exposure Temperature
Max Exposure Temperature
Max Humidity
Ingress Protection
Grounded Heating Element
Moisture and Chemical Resistant
Suitable for Metal Surfaces
Suitable for Plastic Surfaces
Suitable for Hazardous Locations
* Limited applications, consult factory for additional details
** Bend radius for BriskHeat silicone rubber heaters is applicable only in th e direction of the heater
element. (see figure X)
Bend Radius Note:

Bend radius applies to the length direction of the heater only.

If heater width is less than 4 in (102 mm), the heater cannot bend along the controller box portion
of the heater.

Do not bend the width direction of the heater.
Heater Element Direction
LENGTH
Figure X
®
© BriskHeat Corporation. All rights reserved.
SRL-ADJ & SRP-ADJ
Silicone Rubber Heating Blankets
SRL-ADJ SRP-ADJ
Up to 425°F (218°C) Up to 160°F (71°C)
2.5W/in² (0.4W/cm²) 1.25W/in² (0.2W/cm²)
2'' (51 mm)** 2" (51 mm)**
-60°F (-51°C) -60°F (-51°C)
450°F (232°C) 450°F (232°C)
95% 95%
IP54 IP54
✓ ✓
✓ ✓
✓ ✓
✓ * ✓
4