Important Safety Instructions; Agency Approvals; Specifications - BriskHeat FGDH Serie Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER

Do not immerse heater in liquid.

Keep enclosure cover tight while circuits are alive.

Use heater only in approved locations

Keep sharp metal objects away from heater.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:

Only qualified personnel are allowed to connect
electrical wiring.

Disconnect all supply power at the source before
making any power connections.

All electrical wiring must follow local electrical
codes, it is highly recommended that NEC Article
427 is followed.

The person who performs the final installation /
wiring must be qualified for this work.

The end-user is responsible for providing a
suitable disconnecting device.

The end-user is responsible for providing suitable
electrical protection device. It is highly
recommended that a ground fault circuit breaker
is used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
Full-Coverage Drum Heater
(FGDH & FGPDH Series)

Agency Approvals

All FGDH and FGDH series marked with CE marking
Approvals valid only when installed in accordance with
all applicable instructions, codes, and regulations.
CAUTION

Never handle the heater while it is in operation;
Always disconnect the heater from the power
source and allow to cool prior to handling.

Inspect heater before use.

Do not wrap the heater over itself.

If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after
heater is allowed to cool.

Never operate a heater without an appropriate
heat sink (device being heated is considered a
heat sink).

Fasten heater to device using approved methods
only.

Do not repair damaged or faulty heaters.

Do not crush or apply severe physical stress on
heater or cord assembly.

Disconnect heater when not in use.

Use specified sized heater with same sized drum.
Do not use for other applications.
Failure to observe these warnings may result in personal
injury or damage to the heater.
3

SPECIFICATIONS


Adjustable On / Off Digital Controller

50-450ºF (10-232ºC) for FGDH series

50-160ºF (10-71ºC) for FGPDH series

FGDH and FGPDH Series heated area:

55 & 30 Gallon - Heated area is lower two thirds

15 & 5 Gallon - Heated area is lower one third

Patented grounded heating element

Dielectric strength over 2000 volts

Power cord 6' (2m) long

120 or 230 VAC Models

450ºF (232ºC) maximum exposure temperature on heating surface

Intended for use in dry environments. Do not expose to spray.
®
© BriskHeat Corporation. All rights reserved.
Full-Coverage Drum Heater
(FGDH & FGPDH Series)
4