Important Safety Instructions; Heater Characteristics / Specifications - BriskHeat SRL Serie Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and understood all operating
Instructions is not qualified to operate this product.
DANGER
•
Do not immerse heater in liquid.
•
Keep volatile or combustible material away from
heater when in use.
•
Use heater only in approved locations.
•
Keep sharp metal objects away from heater.
•
All SRX heating blankets have T ratings described in
Article 501 of the NEC code. The heating blankets
should not be used in an area with a lower T rating
than the heating blanket. The T rating is stated in
marking on the heating blanket.
•
Do not modify this product. Modification will void
warranty.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:
•
Only qualified personnel are allowed to connect
electrical wiring.
•
Disconnect all supply power at the source before
making any power connections.
•
All electrical wiring must follow local electrical codes.
•
The person who performs the final installation / wiring
must be qualified for this work.
•
The end-user is responsible for providing a suitable
disconnecting device.
•
The end-user is responsible for providing suitable
electrical protection device. It is highly recommended
that a ground fault circuit breaker is used.
•
SRX series: A NRTL (National Recognized Testing
Laboratory) listed temperature controller must be used
to control the surface temperature of the heating
blankets. The controller must be approved for the area
where it is located.
•
SRX series: Heaters provide surface heating, consult
proper authorities for information for safe heating of
materials/ contents of any vessel heated by SRX
heaters.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
SRL, SRP, SRMU, SRX, Custom Series
Silicone Rubber Heating Blankets
DANGER
Immediate hazards which WILL result in severe personal injury
or death.
WARNING
Hazards or unsafe practices that COULD result in severe
personal injury or death.
CAUTION
Hazards or unsafe practices that COULD result in minor
personal injury or property damage.
CAUTION
•
Never handle the heater while it is in operation; always
disconnect the heater from the power source and
allow cooling prior to handling.
•
Inspect all components before use (see page 9).
•
Do not wrap the heater over itself.
•
If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after heater
is allowed to cool.
•
Never operate a heater without an appropriate heat
sink (device being heated is considered a heat sink).
•
Do not operate heater above rated temperature value.
•
Fasten heater to device using approved methods only.
•
Do not use control and heating system if any
component is damaged.
•
Do not repair damaged or faulty control and heating
systems.
•
Do not crush or apply severe physical stress on any
component of system, including cord assembly.
•
DIsconnect heater when not in use.
Failure to observe these warnings may result in personal
injury or damage to the heater.
3

HEATER CHARACTERISTICS / SPECIFICATIONS

Part Series
Max Power Density
(W/in²)
Minimum Bend Radius
Max Exposure Temperature
(232°C)
Max Humidity
Ingress Protection
Grounded Heating Element
Moisture and Chemical Resistant
Suitable for Metal Surfaces
Suitable for Plastic Surfaces
Suitable for Hazardous Locations
1
Limited applications, consult factory for additional details
2
Refer to product label for approved hazardous locations
®
© BriskHeat Corporation. All rights reserved.
SRL, SRP, SRMU, SRX, Custom Series
Silicone Rubber Heating Blankets
SRL SRP SRMU SRX
2.5 1.25 10 2.5
3" 3" 2" 12"
450°F 450°F 450°F 400°F
(232°C) (232°C) (204°C)
95% 95% 95% 95%
IP56 IP56 IP56 IP56
✓ ✓ ✓
✓ ✓ ✓ ✓
✓ ✓ ✓ ✓
✓ 1 ✓ ✓ 1 ✓ 1
✓ 2
4