Tyco DSC PowerSeries Neo HSM2HOST Guia De Instalacion página 6

To manually enroll,
1. Enter Installer Programming section [902][001] (Enroll Modules).
2. When prompted, key in the serial number found on the back of the HSM2HOST. The module is
enrolled.
Delete the HSM2HOST
To remove the HSM2HOST from the system:
1. Enter Installer Programming section [902][106] (Delete HSM2HOSTx).
2. Press [*] to delete.
Test HSM2HOST Location for RF Interference
With the alarm panel powered up and the HSM2HOST enrolled, enter installer programming section
[904]. Observe the status of the red LED. If the red LED is on, interference levels are high and a new
mounting location should be found. If the red LED is off, interference is low and the location is good.
NOTE: For UL/ULC listed systems, signal must be "Strong". See Wireless Device Status
Indications on page 9 for details.
Permanently Mount
Once a suitable location is found, mount the HSM2HOST as follows:
1. Pull the Corbus wires through the holes at the back of the
2. Mount the cabinet securely to the wall using the three screws supplied.
3. To enable the wall tamper, fasten the breakaway wall tamper bracket securely to the wall using the
supplied screw.
Figure 2: Mounting the HSM2HOST
cabinet.
5