Parts & Assembly - Nostalgia Products MSB1AQ Instrucciones Y Recetas

PARTS & ASSEMBLY
PARTS
Blending Chamber
Grinding Cage
Lid
Cord Location
The cord storage is located at the base of the unit:
ASSEMBLY
Attaching and Removing the Grinding Cage
It is very important that the Grinding Cage is assembled properly in order for
the unit to work.
1. The Grinding Cage is attached to
the inside of the Blending Chamber
with a round Plastic Collar.
2. Place the Grinding Cage with the
smooth end (opposite of end
with three tabs) into the Plastic
Collar and twist until the notch of
the Grinding Cage locks into the
protrusion on the Plastic Collar.
3. Turn the assembled Grinding Cage with Plastic Collar over, so Plastic Collar
is on the top to insert into the base of Blending Chamber.
5
Clear Window
Spout
Base
Screws
Plastic Collar
Grinder