CAME ZL19N Manual De Partes página 12

Adjusting the stop zone
Prepare a 60x30 mm template and hold it up against one of the two mechanical stops as shown in fi g. 1 (adjustment is to be made either on the closing
endstop or opening endstop).
Activate the gate - either using a command button or the remote control - and turn the OP TIME trimmer clockwise until the gate leaf inverts its direction just
as it touches the obstacle/template.
Then turn the template from its short side (fi g. 2) and turn the OP TIME trimmer counterclockwise until the gate leaf stops against the obstable/template.
With two-leaved gates, this procedure must be performed on either side.
Fig.1
Fig.3
12
OP TIME
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
Fig.2
A = Amperometric sensor's operating area with
inverted movement
B = Normal speed operating area
C = Slowdown speed operating area
D = Amperometric sensor's operating area with
stopped movement
E = Closing and opening endstops
OP TIME