Shark SV780 N 14 Guia Del Usuario página 16

CHARGING • CHARGEMENT • CARGA
Fig. 5
Fig. 6
ASSEMBLING THE CHARGING BASE
1 Insert the charge adapter plug through the hole in the
underside of the charging base / wall mounting bracket .
(fig. 5)
2 Turn the charge adapter plug one quarter turn to secure
it into place. (fig. 5)
CHARGING BASE / WALL MOUNTING BRACKET
1 If you wish to mount the charging base onto a wall, make
sure that the intended wall area that is to be drilled is
free from any hidden electrical wires, water pipes and
gas lines.
2 Select an appropriate place that is close to an electrical
outlet. Do not mount near direct sunlight, near a heat
source or outdoors.
3 Select an appropriate drill type for the material to be
drilled.
4 Carefully measure and mark the location of all bracket
holes and then drill holes and screw the charging base
/ wall mounting bracket onto the wall. (Screws not
included.) (fig. 6)
16 1-800-798-7398
Fig. 7
CHARGING YOUR HAND VACUUM
1 Plug the charger into the wall outlet. Place the unit in the
charging base. The charging indicator light will illuminate
to show that the vacuum is being charged. (fig. 7, fig. 8)
2 Before first using the hand vacuum, make sure that the
On/Off switch is in the "Off" position and charge it for 20
hours.
3 After the initial charge, the charge time is 16 hours.
4 Always unplug the unit when the charge time is complete.
Fig. 8