Entering Pin Id; Logout Operation; Operation Time-Out - Oki MC360 Guia De Instalacion

Entering PIN ID

• With Access Control Enabled, entering a PIN ID is required to enable setting up
various utilities.
• Enter the PIN ID via the Ten Key pad.
• A valid PIN ID consists of 4 to 9 digits.
• The numbers entered are not displayed on the Enter PIN ID screen, being
replaced by '*'.
• The PIN ID entered can be confirmed by either the Start button or the Enter
key.
• The MFP supports the following 2 kinds of PIN ID:
Administrator PIN ID — This is the PIN ID for the system administrator(s).
If a PIN ID is registered as an administrator, the Admin password entry screen
is displayed, and, when an Admin password is entered, it will be authenticated
as an administrator.
User PIN ID — This is PIN ID for general users. If a PIN ID is registered as a
general user, the function selection screen is displayed, also after PIN ID entry
the function selection screen is displayed.
• Invalid PIN ID: If the PIN number entered is invalid, Incorrect Password is
displayed for 3 seconds and the display reverts to the Enter PIN ID screen.

Logout operation

If Logout is selected or an Operation Time-out occurs, the display reverts to the Enter
PIN ID screen.
Logout by user
With Access Control enabled, Logout options are displayed in the Menu on the Mode
Selection screen.
When the cursor is moved to Logout and the Enter key is pressed, the display reverts
to the Confirm Logout screen.
If Yes is selected with the Enter key on the Confirm Logout screen, the display reverts
to the Enter PIN ID screen.

Operation Time-out

• When the MFP operation panel is left inactive for a prescribed length of time
(Operation Time-out), the display automatically reverts to the Idle screen if
Access Control is disabled.
• If an error state occurs, Operation Time-out is disabled.
• After Operation Time-out, the display automatically reverts to the Enter PIN ID
screen if Access Control is enabled.
• The length of the Operation Time-out depends on the setting in Menu
Mode>Admin Setup >System Setup > Return to Stand-by Time.
12 English