Ebm Setup; Tools Required; Rack-Mount Setup - Eaton Powerware 5125 Guia De Instalacion

INSTALLATION

EBM Setup

The P33 EBM can be purchased separately or factory-installed in an IBM
iSeries
The EBM attaches to a P33 UPS for longer battery runtimes.
NOTE If the EBM is pre-installed in an IBM pSeries (RS/6000
installing the UPS at the same time, follow the instructions in the Powerware 5125
(9910-P33) Installation Guide for IBM Applications.

Tools Required

To assemble the components, the following tools may be needed:
S
S

Rack-Mount Setup

NOTE Check the battery recharge date on the shipping carton label. If the date has expired
and the batteries were never recharged, do not use the UPS. Contact your service
representative.
The EBM can be installed in 19-inch racks and needs only 2U of valuable
rack space.
The Extended Battery Module is heavy. A minimum of two people are required to lift the
EBM into the rack.
NOTE Fixed mounting rails are required for each UPS and EBM cabinet. If fixed rails are
not already installed in your rack, contact your local IBM representative to order a rail kit(s). If
you are installing the EBM in a non-IBM rack, contact your Powerware representative.
2
EATON Powerware
t
or pSeries rack.
®
Medium flat-bladed screwdriver
#2 Phillips screwdriver
® 5125 (9910-P33) EBM Installation Guide for IBM
) system or if you are
®
C A U T I O N
S
® Applications 164201358 Rev C