Hoshizaki FM-600ALHE Manual De Instalación página 2

IMPORTANT
1. In order to carry out safe and proper installation
of the product, please read this booklet
carefully beforehand and follow the instructions
contained within.
2. On completion of the installation, start up the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the
Instruction Manual.
3. This booklet should be handed over to the user
after the installation and be preserved by the
user together with the Instruction Manual for
any further consultation that may be
necessary.
WARNING
The installation must be carried out by
qualified personnel, in accordance with current
regulations, according to the manufacturer's
instructions.
1. UNPACKING
WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
CAUTION
1. Do not lift or manoeuvre the carton by using
the shipping bands.
2. Remove shipping carton, tape(s) and packing.
If packing material is left in the icemaker, it
will not work properly.
Power Supply Cord
Top Panel
Air Filter
Louver
Front Panel
Fig. 1
Note: 1. This icemaker needs a Storage Bin. The
1) After removing the packaging, make sure that the
icemaker and the Storage Bin are in good condition.
If in doubt, please do not use the equipment but
apply to professionally qualified personnel. See the
instruction sheet attached to the Storage Bin for its
unpacking and installation guidelines.
2) Remove the shipping tape holding the Front Panel.
3) Remove the Front, Top and Side Panels. See Fig.
2.
4) Remove the package of accessories, and check
the contents:
Operation Panel
5) Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
1
recommended Storage Bin is HOSHIZAKI
ICE STORAGE BIN, Model B-300SD(PD)
or B-500SD(PD) with Top Kit - 8C, B-
700SD(PD) with Top Kit - 22C, or B-
900SD(PD) with Top Kit - 22C and Top Kit -
8C.
2. This icemaker is designed to be connected
to either a multi compressor rack system
or an individual remote compressor using
R404A. To achieve the set evaporating
temperature of -25°C (FM-600), -22°C (FMN-
440) or -18°C (FM-481), the running suction
pressure of the compressor should be 1 bar
(FM-600), 1.4 bar (FMN-440) or 2.1 bar or
less (FM-481).
Front Panel
Top Panel: Remove the screw(s). Lift off.
Front Panel: Remove the screw. Lift up and
pull toward you.
Side Panel: Remove the screw.
slightly toward you, and lift off.
Fig. 2
a) Installation Kit
Inlet Hose
Outlet Hose
b) Mounting Bracket
ENGLISH
Top Panel
Side Panel
Pull
1
2
2