Pause/Resume; Media Sensor Auto-Calibration - Oki LD620D Guia Del Usuario

5-3 Pause/Resume

Press FEED button to pause at the middle of labels printing.
1) Press FEED once.
2) Printer stops after on-going printing and Red LED becomes on.
3) Press FEED once again. It resumes printing in a queue.

5-4 Media Sensor Auto-Calibration

Media sensor auto-calibration is used when the printer does not detect a gap or black mark
on the label paper correctly.
Generally a printer is set to detect most types of gap or black mark but sometimes it fails to
detect and keep feeding the paper without a stop when special paper used. In such case,
use media sensor auto-calibration function for a proper detection.
1) Make sure that paper roll has been installed properly.
2) Use Stand-alone Configuration Mode, Sequence Number 2 or 3(refer to 5-1)
- Sequence Number 2: Gap Media Auto-Calibration
- Sequence Number 3: Black Mark Media Auto-Calibration.
Rev. 1.0
- 18 -
LD620D