3M DBI SALA 2104711 Manual Del Usuario página 11

Inspection Date:
Components: Inspection:
Sliding Beam Anchor
Inspect the Sliding Beam Anchor damage: Look for cracks, dents, or deformities.
(Figure 2)
Inspect for bending or wear on the Support Tube (A), Connector Ring (B), Connector Ring
Bracket, Hook Ends (C), and Tab Locks (D).
Inspect for any missing parts (End Rivets, Center Screw, etc.).
Inspect the entire unit for corrosion.
Inspect the wear pads to ensure they have not worn to a point where the hook ends will be
in direct contact with the beam flange. Replace worn or cracked wear pads. (see Wear Pad
Removal and Installation)
Inspect the Support Bar (A) Teeth for wear or damage. Ensure that the locking pawl will fully
engage each tooth automatically upon release of the Tab Locks (D).
Ensure the Tab Locks (D) operate freely, spring back fully, and automatically engage with the
Support Bar (A) Teeth.
Labels (Figure 11)
Verify that all labels are present, securely attached and are legible (see 'Labels')
PFAS and Other
Additional Personal Fall Arrest System (PFAS) equipment (harness, SRL, etc) that are used with
Equipment the Anchorage System should be installed and inspected per the manufacturer's instructions.
Serial Number(s):
Model Number:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
1 Competent Person:
One who is capable of identifying existing and predictable hazards in the surroundings or working conditions which are unsanitary,
hazardous, or dangerous to employees, and who has authorization to take prompt corrective measures to eliminate them.
Table 2 – Inspection and Maintenance Log
Inspected By:
(See Section 1 for Inspection Frequency)
User
Date Purchased:
Date of First Use:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Competent
Person
1