Product Description - 3M DBI SALA 2104711 Manual Del Usuario

;
Prior to installation and use of this equipment, record the product identification information from the ID label in the
Inspection and Maintenance Log (Table 2) at the back of this manual.

PRODUCT DESCRIPTION:

Figure 1 Illustrates the 3M™ DBI-SALA™ Sliding Beam Anchor. The Sliding Beam Anchor is a single point anchorage connector
for a personal fall arrest system or personal fall restraint system designed to be attached to a beam.
Figure 2 Illustrates components of the Sliding Beam Anchor. See Table 1 for Component Specifications. The Sliding Beam Anchor
is comprised of a notched Support Bar (A) with a swiveling Connector Ring (B) and adjustable Hook Ends (C) that hook over
each edge of a beam flange with Tab Locks (D) that engage the notches on the Support Bar. The Sliding Beam Anchor slides
smoothly along the beam on Wear Pads (E). A Lanyard or Self-Retracting Device (SRD) is connected between the Swiveling
Connector Ring on the Sliding Beam Anchor and the appropriate attachment element on the user's Full Body Harness.
System Specifications:
Capacity: 1 Person with a combined weight (clothing, tools, etc.) of no more than:
140 kg (310 lbs) for EN 795.
Anchorage The required Anchorage Strength depends on the application:
Strength:
Anchorage Structure: The structure to which the Anchorage Connector is mounted must be capable of
sustaining force in the anticipated direction(s) of loading. Each Anchorage Point location must be capable of
sustaining the following values:
EN 795
Service -40°C (-40°F)
Temperature Minimum Service Temperature
Anchorage 22 kN (5,000 lbs)
Connector Minimum Breaking Strength
Breaking
Strength:
Dimensions: See Figure 1 for the dimensions of each Sliding Beam Anchor model.
Weight: See Figure 1 for the weight of each Sliding Beam Anchor model.
Component Specifications:
Figure 2
Reference Component
A Support bar
B Connector Ring
C Hook Ends
D Tab Locks
E Wear Pads
1
1 Qualified Person:
An individual with a recognized degree or professional certificate, and extensive experience in Fall Protection. This individual must be capable
of design, analysis, evaluation, and specification in Fall Protection.
Table 1 – Specifications
12 kN (2698 lb)
Materials
Aluminum Alloy
Alloy Steel
Aluminum Alloy
Alloy Steel
Nylon
6