GE Evolve ERX1 Guia De Instalacion
  1. Manuales
  2. Marcas
  3. GE Manuales
  4. Equipo de Iluminación
  5. Evolve ERX1
  6. Guia de instalacion
GE Evolve ERX1 Guia De Instalacion

GE Evolve ERX1 Guia De Instalacion

Luminaria led para vía pública
Ocultar thumbs
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Descargar este manual
GE
Lighting
Evolve
™
LED Streetlight (ERX1)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
Risk of electrical shock. Disconnect power before servicing
or installing product.
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class [A] RFLD complies with the Canadian standard ICES-003.
Ce DEFR de la classe [ A ] est conforme à la NMB-003 du Canada.
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
imagination at work
LED Roadway Lighting
WARNING
WARNING
CAUTION
• This luminaire is designed for outdoor lighting service,
and should not be used in areas of limited ventilation,
or in high ambient temperatures.
• Best results will be obtained if installed and maintained
according to the following recommendations.
• Luminaire is designed to operate in ambient
temperatures ranging from -40°C to +40°C and
to be mounted horizontally to a vertical pole with LEDs
facing down, as shown.
SPECIFICATIONS
• Weight: Maximum weight
ERX: 15 lbs (6.8kg)
• IP Rating: Optical IP65, Standard Electrical Enclosure:
UL 1598 Wet Location Rated
Installation Guide
GEH-6018A

Publicidad

Tabla de contenido
loading

Manuales relacionados para GE Evolve ERX1

Resumen de contenidos para GE Evolve ERX1

  • Página 1 Installation Guide GEH-6018A Lighting Evolve LED Roadway Lighting ™ LED Streetlight (ERX1) BEFORE YOU BEGIN Read these instructions completely and carefully. Save these instructions for future use. WARNING Risk of electrical shock. Disconnect power before servicing or installing product. • This luminaire is designed for outdoor lighting service, WARNING and should not be used in areas of limited ventilation, Risk of injury or damage.
  • Página 2 UNPACKING • Once the proper level has been achieved, tighten each bolt to 10-12 foot-pounds, alternating between bolts. • This luminaire has been properly packed so that no If a torque wrench is not available, correct torque parts should have been damaged during transit. may be achieved by turning bolts two to three full turns (or until bottoming occurs) past their snug •...

  • Página 3: Maintenance / Cleaning

    • Attach service leads to terminal board as shown on Optional Screw luminaire wiring diagram. • See table below for screw torques (See Table 1). TABLE 1. Terminal Board Torque Table UL Units Door Latch Wire Range Copper Aluminum Torque (in lbs) 10 - 16 SOL, STR 8 - 6 SOL, STR STR6 SOL, STR...
  • Página 4 (1 - 888 - 69 - 43 - 533) GE Lighting is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company. © 2013 GE Lighting. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.

  • Página 5: Luminaire De Route À Del Evolve

    Guide d’installation GEH-6018A Lighting Luminaire de route à DEL Evolve™ Luminaire routier à DEL (ERX1) AVANT DE COMMENCER ARRÊT Lisez attentivement toutes ces instructions. Conservez ces instructions pour référence future. AVERTISSEMENT Risque de choc électrique. Déconnectez l’alimentation électrique avant d’installer ou réparer ce produit. •...
  • Página 6 DÉBALLAGE • Lorsque l’inclinaison est satisfaisante, serrez les boulons jusqu’à 10 12 lb pi, en procédant • Ce luminaire a été soigneusement emballé pour graduellement en alternance. qu’aucune pièce ne subisse de dommages durant vous ne disposez pas d’une clé dynamométrique, le transport.

  • Página 7: Entretien Et Nettoyage

    • Installez les électriques sur le bornier Vis optionnelle conformément à l’illustration sur le schéma de câblage du luminaire. • Consultez les valeurs de serrage sur le tableau ci-dessous (voir tableau 1). Verrou de porte TABLEAU 1. Tableau de serrage des bornes, appareils UL Plage de grosseurs Aluminium Couple de serrage...
  • Página 8 General Electric Company. Evolve ainsi que la marque et le logo GE sont des marques commerciales déposées de la General Electric Company. © 2013 GE Lighting. Les informations fournies ici sont susceptibles de changer sans préavis. Toutes les données sont des valeurs de conception ou caractéristiques lors de leur mesure en conditions de laboratoire.

  • Página 9: Luminaria Led Para Vía Pública Evolve

    Guía de instalación GEH-6018A Lighting Luminaria LED para vía pública Evolve™ Farol LED (ERX1) ANTES DE COMENZAR ¡ALTO! Lea estas instrucciones de forma completa y atenta. Guarde estas instrucciones para su uso futuro. ADVERTENCIA Riesgo de choque eléctrico. Desconecte la alimentación eléctrica antes de instalar o prestar servicio al producto.

  • Página 10: Desembalaje

    DESEMBALAJE • Una vez alcanzado el nivel correcto apriete cada perno hasta 13.5 - 16.2 N·m (10 - 12 lb·pie), • Esta luminaria fue embalada adecuadamente, de alternando entre ellos. manera que ninguna pieza resultara dañada durante Si no cuenta con una llave dinamométrica, el par de su transporte.

  • Página 11: Mantenimiento / Limpieza

    • Conecte los cables de conexión de servicio a la tira de Tornillo opcional terminales como se muestra en el diagrama de con exionado de la luminaria. • Vea los pares de apriete de los tornillos en la tabla de abajo (Tabla 1). Pestillo de la puerta TABLA 1.
  • Página 12 General Electric Company. Evolve y la marca y logo GE son marcas registradas de General Electric Company. © 2013 GE Lighting. La información suministrada está sujeta a cambios sin aviso previo. Todos los valores son valores típicos o de diseño, medidos en condiciones de laboratorio.

Tabla de contenido