EN
9.1.c - Using the machine
(Figs. 20-21)
DANGER:
Be extremely careful when using the ma-
chine on ramps in order to avoid roll over
or situations which may cause the ma-
chine to lose its balance.
DANGER:
Avoid sudden sharp turns. Turn the wheel
from lock to lock only at low speed, al-
ways considering ground conditions.
-
After having started the machine and
chosen the type of cycle, select the de-
sired movement direction using the se-
lector (1).
-
Turn on the rotating flash lights (2) and the
operating lights (3).
-
Use the accelerator (4) to begin the clean-
ing operations.
NOTE:
Release the accelerator to stop the rotation
of the brushes and the dispensing of water.
NOTE:
Proper floor cleaning and drying is performed
by driving the machine forwards. When driv-
ing in reverse, the squeegee is raised and
the suction unit, for removing the water from
the floor, is deactivated.
-
If necessary, use the flow adjuster (5) to
adjust the quantity of cleaning solution.
-
Check the charge status of the batteries
on the display (6).
Fig. 20
2
6
EN - 24
4
3
1
7
5
Fig. 21