Cleaning The Side Skirts - Ghibli 5 Serie Uso Y Mantenimiento

EN
11.1.h - Replacing the squeegee rub-
ber blades (Fig. 32)
When it becomes clear that drying the floor
is difficult or traces of water remain on the
floor, it is necessary to check the wear on the
squeegee rubber blades (1):
- Remove the squeegee unit (1) as indicat-
ed in the "Cleaning the squeegee" para-
graph.
- Loosen the finned nuts (2) and remove
the rubber blades (3).
NOTE:
When the rubber blades (3) are worn on one
side, on one occasion they may be turned
over.
- Replace or turn over the rubber blades
(3) without inverting them.
- Replace all the components in reverse
order.
NOTE:
Two types of rubber are available:
Para rubber for all types of flooring and poly-
urethane rubber for workshop floors with oily
residues.
11.1.i – Replacing the side skirt
rubbers (Fig. 33)
When it becomes clear that the washing water
is not well held by the side skirts, it is necessary
to check the wear status of the rubbers (1):
- Remove the side skirts as indicated in the
"Cleaning the side skirts" paragraph.
- Unscrew (2) and remove the rubbers (1).
NOTE:
When the rubber blades (2) are worn on one
side, on one occasion they may be turned
over.
2
1
2
- Replace or turn over the rubber blades
(1) without inverting them.
- Replace all the components in reverse
order.
EN - 32
3
2
Fig. 32
1
Fig. 33