Driver Change - Siemens VDO MTCO 1324 Instrucciones De Servicio

Driver change

Chart
driver 1
Record as
driver 2
Driver change
In case the driver changes the vehicle during
his daily working time, he has to take the
chart with him and note the vehicle change
on the rear of the chart.
Case 1:
The crew changes among themselves,
driver 2 becomes driver 1:
 Exchange the charts.
½ Driver 1 (now driver 2) places his chart
below the separating plate and driver 2
(now driver 1) on the separating plate.
30
 Select the desired time groups.
½ The new driver 1 presses the key
Case 2:
Driver 1 or driver 2 leaves the vehicle:
 The respective driver takes his chart with
him.
 The new driver 2 places his chart below
Chart
driver 2
the separating plate.
or:
The new driver 1 places his chart on the
separating plate.
Comment
In case there is no new driver 2, the time
group has to be switched to break time "
otherwise an error message will be displayed.
Case 3:
Driver 1 and driver 2 both leave the
vehicle:
Record as
driver 1
 Both drivers remove their charts from the
device.
 The new crew inserts the chart according
to their respective functions
(driver 1 or driver 2) in the device.
the driver 2 the key
,
.
",
Kienzle MTCO 1324