The rear side of the chart
(Page 151, figure VII)
The EEC tachograph has two basic chart
types:
c) without rpm recording
d) with rpm recording
1) Entry field for the time groups
This entry field is used for manual entries
of the time groups. Manual entries are
required if, for example, the crew
members work away from the vehicle and
therefore are not able to operate the
tachograph or else in case of a failure of
the time group recording mechanism.
2) Centre field
In the centre field, up to three vehicle
changes may be entered manually.
The following data is required:
time of vehicle change
the registration number of the new
vehicle
odometer reading at start of journey
odometer reading at end of journey
distance travelled
(may be entered)
38
3) Approval mark field
This part of the rear side contains
information on the approval numbers of
the chart and the devices for which the
chart is approved.
4) RPM recording (option)
The temporally exact recording (in rpm) is
carried out on the rear side of the chart for
driver 1.
Note
The markers (4a) will be displayed for ig-
nition on / off.
Kienzle MTCO 1324