How To Use - HoMedics UHE-CM25TGT Manual De Uso

How To Use

Power/Mist Knob
Night Light
Illuminated Ring
Power/Mist Knob
Plug unit into a 120 volt AC electrical outlet. Turn the POWER/MIST (
turn the humidifier on.
ATTENTION: When the water in the tank is almost empty, the humidifying function will power
off to indicate to the user to refill the tank.
Mist Adjustment Setting
Mist adjusts from MINIMUM ( ) mist to MAXIMUM (
turn the POWER/MIST knob clockwise. To decrease mist output, turn the POWER/MIST
knob counter-clockwise.
Night Light
Press the NIGHT LIGHT ( ) button to turn on the night light. The surround around the
POWER/MIST knob will glow softly.
Mist Selection Dial
Night Light ON/OFF
Button
Fig. 2
) knob clockwise to
) mist. To increase the mist output,
6
How to Fill
CAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet.
NOTE: Always use two hands to carry the water tank.
1. Grasp tank handle and lift up from humidifier base. (Fig. 3)
Fig. 3
2. Turn the tank upside down—remove the tank cap by turning it
counter-clockwise. (Fig. 4)
Fig. 4
3. Fill the water tank with clean, cool (not cold) water. We
recommend using distilled water if you live in a hard water area.
(Fig. 5)
Fig. 5
4. Replace the tank cap by turning clockwise until tight. (Fig. 6)
Fig. 6
5. Install the tank back on the base of the unit. Make sure the tank
is firmly seated. (Fig. 7)
NOTE: It is normal to have a small amount of water
in the base during and after use.
Fig. 7
7