How To Use - HoMedics UHE-WM250 Manual De Instrucciones E Información De Garantía

How To Use

Power ON/OFF Button
Plug unit in to a 120 volt AC electrical outlet. Press the POWER button to turn unit on. Press the
POWER button again to turn unit off. ATTENTION: When the water in the tank is almost empty, the
unit will shut off to indicate to the user to refill water.
Mist Output Level
Mist adjusts from the lowest output 1 to the highest output 5. To increase the mist output, press
the + Button. The corresponding Mist Level will be lit on the display. To decrease mist output,
press the – Button.
Mist Temperature Setting
When the humidifier is powered ON, it will be operating on the last setting used.
To change the mist temperature from Cool to Warm Mist, press the Mist Temperature Button. WARM
will be illuminated on the display. To change the mist temperature from Warm to Cool Mist, press the
Mist Temperature Button again. COOL will be illuminated on the display.
NOTE: Once Warm Mist is selected, it will take 20 minutes to heat up before the mist becomes warm.
Programmable Humidistat
The Programmable Humidistat can be set in 5% increments from 35% - 65% humidity.
To program the humidity level, press the Humidistat Button. Then press the + / - Button. The humidity
level will increase / decrease by 5% every time the + / - Button is pressed and will show on the
display screen. Keep pressing the + / - Button until the desired programmable humidity setting is
reached. The display will show the set humidity level for 3 seconds, then default back to display the
current room humidity.
NOTE: To eliminate any programmed Humidistat setting, press the Humidistat Button. Then press the
+ Button until you reach "CO" (continuous on) one level above 65%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the
room drops 5% below the set humidity level, then will cycle on until the set humidity level is reached
again.
Night Light / Display Light
Press the Night Light / Display Light Button once to turn on the night light. The light at the bottom of
the water tanks will turn on, illuminating the tanks. Press a second time to leave the night light on, but
turn off the display light. Press a third time to turn off the night light and display light so no lights are
illuminating. Press a fourth time to turn the display light on.
Timer
Press the Timer Button. Keep pressing the Timer Button until the desired timer setting is lit on the
display. The Timer Button will cycle through the following settings 0 hours, 2 hours, 4 hours, 8 hours,
12 hours, 0 hours. To turn the Timer off, press the Timer Button until 0 hours is shown on the display.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
6