Instructions for use
OPENING THE PICOROCO (diagrams 1-2)
•
Hold the lower part of the hammock while pressing the opening button
on the top part. Pull the front tab upwards (fig.1).
•
Pull the front tab upwards, while using the other hand to hold the bottom
part of the Picoroco (fig.2). It will click when correctly fastened.
FITTING THE MATTRESS PAD (diagrams 3-5)
•
Unfasten the buckle of the safety harness, pressing the grey button in
the middle. (fig.4)
•
Place the mattress pad on the Picoroco and insert the crotch strap
through the central vent. (fig.3-4)
•
Place both straps in the corresponding shoulder pads and fasten them
in using the Velcro on the pads. (fig.5)
SAFETY HARNESS (diagrams 4-6)
WARNING: Always use the restraint system.
•
Before placing the child in the Picoroco making sure that the buckle is
unfastened. To do this, press the middle button and separate the two
clips. (fig.4)
•
Place the child in the hammock and adjust the length of the straps
(shoulders and crotch strap), by pulling the end of A and part B. The
harness should be fitted to the child's body but without being too tight.
•
Lastly, insert the two clips into the slots in the buckle, it will click when
correctly fastened. (fig.6)
ADJUSTING THE BACKREST (diagrams 7-8-9 )
NOTE: The backrest of the PICOROCO has two reclining positions.
WARNING: Any adjustment to the hammock (changing the position of the
backrest, carrying) should be made when the child is not using it.
WARNING: Check that the backrest is correctly locked into one of the two
reclining positions before placing the child in the hammock.
•
Take the child out of the Picoroco.
•
Press the button on the bottom part of the Picoroco,(fig.7) and place
11